Neutron Gear offers security uniforms and security products;
Security vests, security pants, security caps, security boots, and security belts. Security coats should be made from a breathable fabric. Security coats are sewn, in front of the full-length zipper. The hidden zipper is sewn up, to hide the mounting of the front zipper. The inner collar is made of a soft material to prevent skin irritation. The ventilation pockets are sewn on the right and left front. Under the right ventilation pocket, a radio pocket is sewn. The arms of the safety jacket must be removable.
The zipper is used to prevent outside air from entering. The lining of the safety jacket is made of fixed mesh fabric. Security uniforms should be made from heat-resistant fibers. Security shoulder pads are made with a black plastic snap fastening under the collar. The shock-absorbing protection must be placed on the shoulders and elbows of the safety jacket. The safety pants, on the other hand, are made from the same fabric from which the safety jacket is made.
NEUTRON GEAR SECURITY EQUIPMENT
Neutron Gear offers a very wide choice of qualified security uniforms and equipment.
NEUTRON GEAR SAFETY HELMETS
Safety helmets are made from impact-resistant and waterproof materials. The inner protective layer of the safety helmet is made of material that absorbs external shocks. The inner materials of the safety helmet are used for human health, have anti-allergic and anti-bacterial properties, and can be inserted and removed for cleaning. The visor of the safety helmet protects from both UVA and UVB rays, the minimum reflectivity being 95% of the property; this must be in the form of a sticker stuck on the helmet.
THE NEUTRON GEAR SECURITY SHIELD
Neutron Gear’s security shield is rectangular, and the sides are bent inward, at an angle of 30 (210) degrees, 10 (+1.5) cm in length. It is resistant to shocks and blows from stones, metal rods, Molotov cocktails, dangerous chemicals, etc. In the event of unfavorable resistance, when the shield is too forced, its flexion in or out is minimal. In the case the shield is exposed to bending, it does not break. The armrest (where the arm is bent) is smooth-surfaced and made of polyurethane, to absorb vibrations in the event of an impact, also supporting the arm from top to bottom, and adapted to the structure of the arm.
The handle is adapted to the structure of the hand, also orthopedic, ergonomic, and made of durable aluminum metal covered with polyurethane. The cuff wraps around the arm, just beside the elbow, allowing it to open in case the shield is pulled. The support is one piece from top to bottom. The handle of the shield is made of ergonomic, non-irritating, and impact-resistant material, which also suits the angle of handling of the arm. The polycarbonate material has resistance up to +50 and – 50 ° C, it is flexible and has resistance to large impacts as well.
The shield is clean and clear and there are no waves or air bubbles, also providing the user with a clear view. Regarding the retention side, there is a baton holder inside the long right side, made of polyethylene and mounted on the shield. The baton holder can hold the baton stationary and is flexible so that when pulled towards you, it can easily loosen and leave the baton, but is also durable, so as not to break, in case of bending.
You can check all our security uniform models under this category and you can see more detailed specifications about security uniforms in the product details section.
